Elastic Waterproofing Protection
Elastoseal is a Clear Acrylic Elastomeric Sealant designed to seal and protect a wide range of surfaces, everything from reflective roof coatings to log cabins.
Until now clear protective coatings lacked flexibility which is necessary as roof coatings and wood surfaces expand and contract.
Elastoseal is based on the same resins used in our highly flexible insulating roof coatings and features the same elongation, expansion and contraction properties of those coatings.
Elastoseal also features outstanding adhesion to the applied surface, elongation and recovery capabilities, a combination of UV absorbers and mildewcides enabling it to resist the effects of the most severe climatic conditions.
Now all roof coatings can be protected from surface contamination enabling them to perform as intended by reflecting radiant heat away from the buildings interior. Log Cabins and other wood surfaces can now be sealed and protected with a finish that will expand and contract with the wood.
The self cleaning clear coat works much the same way as the clear coatings designed and used on automobile finishes.
Elastoseal is truly an all-purpose clear sealant, suitable for virtually any sealing application.
Color: Milky White, dries clear.
Volume Solids: 41% ± 2%
Flash Point: Same as water.
Coverage: 350-400 sq.ft. per gallon depending on the porosity of the surface.
Recommended Coverage: The number of coats depends on surface porosity; however, one coat is all that is normally needed.
Min. Surface Application Temp.: 7.2ºC / 45ºF. Do not allow to freeze.
Drying Time: Will depend on climate conditions. Allow at least 2 hours drying time between coats. First coat must be thoroughly dry before applying second coat.
Packaging: 5 gallon buckets, 55 gallon drums.
Limitations Not suitable for below grade use.
Surface Preparation Surface must be clean and free from dirt, dust, grease, oil, mildew, wax, loose paint. Roof Shingles should be sealed with Bond-it, our roof grade bonding/sealer for roofs to lock in loose granular minerals.
Application: Best applied by airless spraying or pump up type tank sprayers. Can be applied with a short nap roller cover.
Clean Up Cleanup immediately after use with soap and water.
Do not apply within two hours of sunset, rain, fog or freezing temperatures. All coatings must be completely dry before exposing to water or foot traffic. Keep all containers covered when not in use. Dispose of all containers in accordance with state and local environmental regulations. Keep away from children. If ingested, DO NOT induce vomiting. Call Physician immediately.
We Supply the Solutions
You Just Need to Apply Them